What is the percentage of solids present?
Describe the liquid phase of the liquid to be filtered (Chemical or technical description)
Is the liquid (Check off as appropriate)
What is the specific gravity of the liquid to be filtered?
What is its viscosity at filtration temperature?
What is its viscosity at room temperature?
Are the solids (in the wet and dry stage, before and after washing of the cake)
What is the particle size in micron?
What is the particle size distribution (PSD)?
What is the sedimentation speed of the solids in the slurry?
Is the process
What is the flow rate of your continuous process?
How many gallons is your batch size?
How many batches per 24 hours?
What is the time span in which a batch must be filtered?
Is the purpose of your filtration to obtain:
At what temperature do you wish to filter
Must you wash residue in the filter?
What is the wash medium and temperature?
How must the filter residue be discharged?
How will you dry your cake:
At what temperature will you dry the cake? Enter temperature in degrees C
What type of filter has been used for this purpose up to now?
What size of filter has been used for this purpose up to now?
What type of screens has been used for this purpose up to now?
Do you precoat your filter?
What type of precoat do you use?
Is it necessary to add body feed?
What is the amount of body feed required, % Concentration?Choose one:
What is the filtration rate in your existing filter, or obtained from tests?
What is the pressure drop in your existing filter at the end of filtration?
What maximum filter cake thickness can you achieve?
Based on your Knowledge of your product, what materials of construction should be used for the filter?
What type of filter plates are required?
Which material is required for your filter screens?
Which nominal micron retention size is required for your filter screens?
What type of filter nest configuration would you prefer?
What gasketing material is required?
What o-ring material is required?
What type of upper seal is required?
Would you require a seal pot?
What type of lower bearing/seal is required?
What type of Funda drive would you need?
Is a jacket required?
What is the design pressure and design temperature of the jacket?
Is insulation with a welded sheathing required?
What is your interior finish of the vessel?
What is the RA finish?
What is your exterior finish of the vessel?
What type of body flange clamping type would you prefer?
What type of cake discharge valve would you require?
Do you want us to supply you with a control system?
Do you require Clean-In-Place for your Funda filter?
Are you interested in renting a Funda Filter?
Are you sure what type of filter is best for your process?
Which rental unit would you like to use?
For how many weeks would you like to rent a Funda filter?
Will you need installation process or operation support?
Where would you like to perform these tests?
Additional comments and application data